Milling Attachment

Box 88
Pine Grove Mills, PA  16868
I welcome phone calls and emails -  

This milling attachment can be mounted on South Bend 9 inch and 10K lathes as well as on the S-4382 cross slide. It can also be mounted on the A-11 cross slide using the S-4382A milling base. The "T" slot vertical slide can be rotated 360 degrees on both the horizontal and vertical axes. The kit consists of six iron castings, drawings, and illustrated machining instructions, including the castings for a vise accessory (seen at the left in the photo) that can be mounted in the "T" slots. (Note, though, that the milling base (S-4382A) shown in the photo is a separate item. See description.) A machined Acme nut for the vertical slide can be supplied for $32.00 extra. The milling attachment shown here was made using only a 9 inch South Bend lathe equipped with a "T" slot cross slide and some special fixtures. Nevertheless it is highly recommended that the machinist who does not have access to a milling machine consider the U-12 transfer block as a prior project, since it will be needed if the milling attachment is to be machined on the lathe.

Shipping wt. approx. 21 lbs.
$139.50 plus shipping
Drawings only $13.50:

MLA-5 and S-4382A

Above, THE MILLING ATTACHMENT shown with the vise jaws, mounted on the S-4382A Millling Base. Refer to the description of the Milling Base, sold separately.

Domestic (U.S.A.) Canada
(limit of 20 lbs.)

The above rates are FLAT RATE Priority Mail.

Return to Home Button